[. . . ] Sonneteer Brontë Digital amplifier Instruction Manual introduction Thank you for purchasing the new Sonneteer Brontë Class-T digital integrated amplifier. [. . . ] In case of any of the above occur during operation, the amplifier will automatically disconnect its output from your speakers (and the Stand-By LED will glow at half brightness). If this happens please disconnect from mains, turn your volume control down, check your connections and reconnect the amplifier. Note: By switching the amplifier to Stand-By will not reset the protection circuitry, please disconnect from mains and reconnect after checking all connections. If the symptom presists, consult your dealer. Rear Panel connections: AC IN: Connect to mains outlet. (Do this after all conenctions to the amplifier have been made and checked) Right Output: Connect this out to your Right Speaker (Red = Positive). 12V DC: Pre Out: Ln Out: CD - L5: This is used to simultaneously switch on the optional Bronte power amplifier. (top row = Right channel, bottom row = Left Channel) If you are experiencing static build-up interference in your system, connect the optional Earth Cable Supplied here to your CD player. Earth Tag: Remote Control Functions Stand-By button: Turns the amplifier on or Stand-by. Left / Right: Scroll source selection left or right. Other useful amplifier features: Each time the mains is connected, the amplifier will automatically go into Stand-By mode. [. . . ] If your remote fails to operate the amplifier, please check the batteries first and that the IR sensor on your amplifier is not obstructed! [. . . ]